lap joint

英 [læp dʒɔɪnt]

美 [læp dʒɔɪnt]

（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝

计算机化学

英英释义

noun

• joint made by overlapping two ends and joining them together
  Synonym:splice

双语例句

• However, further increasing of RE content would degrade the shear properties of the lap joint.
  而当稀土含量进一步增加时，焊点的强度及塑性均下降。
• Test shows that this way can exhibit good result to butt joint and lap joint of TIG welding and accurately abstract welding seam out, to the welding seam of large magnitude dogleg angle shows good tracking effect ( dogleg angle< 68 °) and procession speed< 100 ms.
  实验表明，系统对TIG焊的对接和搭接焊缝有很好地处理效果，对大幅度折线焊缝也能很好的跟踪（折线角>68°），处理速度>100ms。
• Numerical analysis on stress distribution in adhesive-welded double lap joint of aluminum
  铝胶焊双搭接接头上应力分布的数值分析
• The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.
  搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。
• We can obtain the good appearance and defect-free brass and aluminum alloy lap joint when selecting the appropriate parameters.
  焊接时选取合适的工艺参数，可以获得外观形貌良好且无缺陷的异种材料焊接接头。
• Study on Laser Welding for Lap Joint of Stainless Steel 'Case
  不锈钢机匣组件激光叠接焊工艺研究
• The structure of intersecting Lap joint Between steel pipe has been widely applied in engineering project, such as Oil and gas pipelines, Pressure vessel and Various forms of pipe truss structure.
  工程中钢管与钢管的相贯搭接广泛的应用于油气管道、压力容器以及各种形式的管桁架钢结构中。
• By comparing the results of buckling analysis, the effects of material nonlinearity, geometric imperfection and lap joint on stability were studied.
  分析了材料非线性、几何缺陷和筒壁搭接对稳定性能的影响。
• The research is carried out with the method of orthogonal test to study the effects of some main parameters such as Poisson ratio, elastic modulus and adherend of thick on the peck value of the Von Mises equivalent stress distributed in adhesively bonded aluminium single lap joint.
  运用正交试验法研究了几个主要力学和几何参数如泊松比，弹性模量和被粘物厚对单搭接接头VONMISES等效应力的影响。
• Most scholars mainly adopted one dimension variation analysis model, and took qualitative analysis on the butt joint, lap joint of the parts in the research field of assembly sequence optimization which targets was dimension quality.
  以装配尺寸质量为目标的装配顺序优化研究方面，多数学者主要采用一维的偏差分析模型，对零件间的对接、搭接等接头形式进行定性分析。